Xiaomi Mi MIX 4 disassembly: supports 100W wireless charging

Xiaomi released its first smartphone with an under-screen camera yesterday. The Xiaomi Mi MIX 4 is the company’s latest flagship smartphone and its the first MIX device in three years. Today, two disassemblies of this smartphone from Lou Bin, and Geekbar Zhang Lei shows the internals of this device. This smartphone is cheaper than expected and in its first official pre-sale, it sold out swiftly.

Xiaomi Mi MIX 4

The Xiaomi Mi MIX 4 comes with an integrated lightweight ceramic body. Of course, for the signal, there is a very narrow metal frame between the screen and the ceramic. The design makes the antenna short and hard to detect.

To disassemble this smartphone, the first step is to shut down the device and take out the SIM card tray. Then heat all the sides with a heating pad or an air gun at 90 degrees Celsius, and gently pry out the gap with the disassembly piece. You will use the disassembly piece to separate the rear case from the screen. When separating the rear case and the screen/motherboard, you need to be careful about the USB Type-C port at the bottom to avoid pulling it off.

Xiaomi Mi MIX 4

The motherboard adopts a common three-stage structure. The upper part is mainly SoC, camera CMOS, memory flash memory, UWB antenna, etc., the middle part is NFC/wireless charging coil, dual-cell battery, and the lower part is the integrated speaker, linear motor, USB, and other modules.

In terms of heat dissipation materials, a large amount of heat dissipation film, copper foil, and thermal grease is applied to the chip part. Lou Bin did some measurement of the temperature of the chip during gaming. For top games like “Honor of Kings” and “Peace Elite”, the average temperature is between 36 degrees and 39 degree Celsius. This is after 30 minutes of gaming.

The LPDDR5 memory comes from Samsung, while ROM is from SK Hynix. The battery is from Dongguan New Energy, while the speakers, and microphones are from AAC Technologies.


When it comes to the under-screen camera, under strong light, you can see two obvious light-transmitting holes on the top of the screen. The circle is the front camera while the square is the distance/ambient light sensor. The former has higher light transmission.

In addition, although Xiaomi advertised that the MIX4 supports 50W wireless charging, the actual measurement can reach 100W. Users can only achieve the 100W wireless charging if they use the sailing wireless charging base. With this device, users can get a full charge in just 36 minutes. The 120W wired fsat charging gives a full charge in 20 minutes. This smartphone comes with a 4,999 yuan starting price.

Source/VIA :

Leave a Reply

Your email address will not be published. Required fields are marked *